Zoc terminal tutorial serial port5/19/2023 ![]() There are a lot of other commands available via the user terminal mode. The Bus Pirate read 0x41, which is what that register is supposed to contain! Other Commands Here is how the Bus Pirate responds to that input: I2C> Let's put all of those addresses into Bus Pirate syntax and in the format that the LSM303C will respond to. Let's take a look at the LSM303C datasheet to see what it expects to see on the I 2C bus: We are ready to start communicating with the IC. The LSM303C Breakout already has pull-up resistors, so we can skip this step. To do so you need to connect the VPU pin to the correct voltage supply. To power the board we need to enable the power regulators with 'W' ('w' will disable): I2C>WĪt this point you might also want to enable pull-up resistors. Let's select 400KHz mode, because we can, so why not? (1)>4 We say above from the help that m is the 'Change mode' command. The first step is to select the correct mode. The default baudrate of the Bus Pirate is 115200 baud, and the hardware I have in hand shows up at /dev/tty.usbserial-AL00ESEO. I connect with a command such as picocom -b115200 /dev/tty.usbserial-AL00ESEO. You can use about any terminal emulator you like. On Mac or Linux, I typically run picocom. Note: By default VDD
0 Comments
Leave a Reply. |